5 d

The most likely cause of it crank?

this is an intermiten problem. ?

Cranks and cranks but won't start, is a symptom of a bad Crank Position Sensor (CPS) located on the transmission bell housing. Test the Crank Position Sensor. Despite the fact that the CKP and Cam sensor are new, they should be tested, especially if they are not genuine Jeep parts. You should get a reading of If you are down in the. Sold '00 TJ, 4" lift, rusty's adjustable control arms, skyjacker shocks, rock krawler adj. todaypercent27s cryptoquip puzzle 35 AC volts range or lower on your meter reading, you can have intermittent crank/no-start conditions from your Renix Jeep. This means that the CPS/CKP fails when engine gets hot, but works again when it cools back down. Went to restart, turns over but won't fire up. I was driving it around for a few weeks and now it won't start. cvs refill guest Sold '00 TJ, 4" lift, rusty's adjustable control arms, skyjacker shocks, rock krawler adj. They are free or low cost, easy, and usually what causes the problem. 0 cranks, has spark and fuel but won't start (Sold:redface:)1994 Jeep Wrangler 2. Often this part is also referred to as the CranKshaft Position Sensor (CKP) CPS/CKP failure is very common. The most likely cause of it cranks and cranks but won't start up is the Crank Position Sensor (CPS). jack knife sofa Went underneath the Jeep with a wrench and banged on the starter a few times and it fired right up. ….

Post Opinion